Expand your canopy power setup with the iTechworld Expansion Super Slimline Canopy Dual Battery Kit. Built around the iTECH300SS 300Ah Super Slim Lithium LiFePO₄ Battery, this system delivers massive capacity, fast charging and full control for serious off-grid or commercial builds.
The iTechworld Premium Control Hub integrates a 40A DCDC + MPPT Charger and 500A Shunt for complete system management, while the 2000W PRO Pure Sine Wave Inverter provides clean 240 V power for appliances and tools. An RC3 PRO Remote gives you easy on/off control, and the iTECHBC40 40A AC Charger ensures rapid mains recharging when you’re home or at a powered site.
Charging and protection are handled through 00 AWG Inverter Cables with a 250 A Maxi Fuse, plus a Plug and Play 40A DCDC Wiring Kit for tight canopy installs. The 200 W Hard Frame Solar Panel completes the system for continuous solar input and total energy independence.
Perfect for 4WD canopies, service vehicles, caravans and advanced off-grid systems, this setup offers high output in a compact footprint. Built for Australian conditions, it delivers the reliability, efficiency and control expected from iTechworld’s premium power systems.
Whether you’re running tools on site, powering appliances in remote areas or upgrading a full touring rig, the iTechworld Expansion Super Slimline Canopy Power System gives you next-level energy capacity, fast charging and complete autonomy anywhere you go.
Specs
General
Voltage:
12V
Nominal voltage:
12.8V
C20 rating usable capacity:
300Ah
Short circuit protection:
Yes
Optimum temperature range:
5°C ~ 60°C
BMS operational temperature range:
-40°C ~ 80°C
Safety protection isolator:
80°C
Recommended charge voltage:
14.4V
Maximum charge current:
150A
BMS charge cutoff:
15V
BMS low voltage cutoff:
8.5-9V
Series connection:
Up to 48V (4 x batteries)
Parallel connection:
Unlimited
Life cycles @ 80% depth of discharge:
5,000+
Life cycles @ 40% depth of discharge:
10,000+
Continuous Discharge Rate:
200A
Maximum Discharge Rate (5 Seconds):
640A
Dimensions (LxWxH):
526 x 126 x 450mm (578 L with brackets and 470 H including terminals)
Weight:
38.25kg
Terminal type:
M8
Case material:
Stainless steel
General
Maximum continuous output:
2000W
Peak output:
4000W
Battery compatibility:
Standard lead-acid, AGM, Gel or LiFePO4
Input voltage range:
10.5-15.5V
Output plug rating:
10A
Output voltage & current:
240V - 50Hz
No load draw:
<1.3A
Efficiency:
90%
Output waveform:
Pure Sine Wave
Total Harmonic Distotion (THD):
<3%
IP rating:
IP22
Operating temperature:
-10°C ~ 50°C
Storage temperature:
-30°C ~ 70°C
Over voltage protection:
15.5±0.2V DC
Under voltage protection:
10.5±0.2V DC
Short circuit protection:
1 second
Dimensions (LxWxH):
459 x 265 x 97mm
AC transfer switch:
30ms
Remote terminal:
RJ12
Remote dimensions (LxWxH):
86 x 86 x 19mm
Safety certifications:
The iTechworld inverter range fully complies with AS/NZS 4763:2011 and IEC/EN 62368-1 including Australian deviations
Weight:
7.0kg
Control Hub
Dimensions (LxWxH):
403 x 304 x 116mm
Dimensions w/ DCDC (LxWxH):
403 x 304 x 119mm
Outputs:
2 x 12V 15A cigarette outputs USB-C output 3 x QC3.0
Inputs/outputs:
4 x 50A Anderson plugs
Inputs:
3-pin 50A Anderson plug (DCDC alternator input) 50A Anderson plug (DCDC solar input)